We mill our Glock RMR cuts to a depth of .125″. We also mill out front recoil posts, this also aids in securing the optic in place.
It is recommended to send in your slide completely stripped. This saves us a lot of time, which brings the lead times down.
This is for Glocks only. Our RMR cuts don’t work for the following Glock models; 17L, 41. 42, 43, 43x. 48. (smaller slides)
IF YOU ARE MOUNTING AN RMR THAT IS NOT HOLOSUN OR TRIJICON. YOU MUST SEND IN THE OPTIC TO US SO WE CAN FIT IT!
NOTICE: For Glocks we do not require sending in the guns fully stripped. Please note though, we are not responsible for any parts lost or broken from removing them from the frame/slide etc.
If your sights are on, we will remove them & send it back with your slide. We do not install the sights back on. If you send in your RMR red dot, we will properly install it to the correct torque spec. If you purchase iron sights from us, then we will install those with no installation fee whenever you send in your slide for work. We will have iron sights & red dots for sale.
We include the set screws & L wrench for our RMR cuts. If you are mounting a Trijicon RMR, use our provided screws. If mounting a Holosun, use their provided screws (the shorter ones). We insert a new channel liner anytime a Glock slide gets Cerakoted.
MAKE SURE TO CHOOSE EITHER LOCAL DROP OFF OR FIREARMS CUSTOMIZATION (YOU SHIP TO US & PROVIDE A RETURN LABEL FOR US TO SEND IT BACK) AT CHECKOUT. IF CHOOSING TO DROP OFF, YOU MUST CONTACT TO SCHEDULE.